Beiträge von tirli

removed oem panel and how process was going dont have photo where was cutted on display housing but in photo you can found it where

Hello everyone. i promise job result, here is job results

Still not fully functional sat nav not working, waiting delivery shark fin gps,dab,fm antenna for replace oem antenna.

Also waiting diagbox cable for activate rear camera,parking assistance.

Mood light fully working and functional.

Frame was created using fibre glass on factory panel , display housing some parts was cutted. part not yet finally painted, will be fully painted after speedometer housing done

Next will be cockpit from 3008 in couple weeks starting create frame

hello. you here also

Hello. already sorted have blue,red,green and gold colours

also panel done ready for polishing

thank you everyone for help. unit fully working and installed. nac wave 3 hd sw19 from 2020 208 1.2 installed to 208 1.4hdi 2012. all functions working including steering buttons and all info in out speedometer. using arduino uno v3 can shield, pins from obd2 pi3 can high,pin 5 gnd, pin 8 can low. unit cal file 508-R8 9693370980

any one knows how to change display colour? right now have only blue and green. where is red colour?

thank you again. i will update post after i power up everything

thank you for answer. i have around 10x uno. im working with smart home. Also uno i buy long time ago when it was so cheap if i good remember it was 5x for 15eur. i buy shieldtoday it cost also 18eur

i order shield for uno. Mcp2515 v3. Works on it or i need buy same as your mention?

Hello everyone. Need help with power on nac. Any one can help with pins are for 12v gnd to turn on radio at home. Wanna upgrade smeg to nac. Thank you